In LinkWare, you may see ACR-N appear with N/A next to it rather than a?PASS or FAIL. An example is shown below:
If you are testing to any ANSI/TIA standard, you will always see N/A (Not?Applicable) next to ACR-N since ACR-N is not a requirement in ANSI/TIA standards. It is however reported because many customers expect to see ACR-N on the test report. The limit line on the graph should ideally be black and not red; an enhancement request has been made to engineering.
ISO/IEC standards do require ACR-N. However,?you may also see N/A appear if the Insertion Loss of the disturbed pair is less than 4 dB for the entire measurement frequency; often referred to as the 4 dB rule. It only applies to ISO/IEC Permanent Link testing and NOT Channel testing.
Conclusion
There is no corrective action for you to take. Your tester and LinkWare are following the standard you selected.
新一代中文手持式測試儀 – 省時省力。
新一代中文手持式測試儀 – 省時省力。
新一代手持式網絡分析儀 – 省時省力。
新一代快速OTDR測試儀 – 省時省力。
